Tagged: ,

This topic contains 3 replies, has 2 voices, and was last updated by  haishen201 11 months, 1 week ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #2277

    misudo
    Participant

    The manual says the following:
    “When printing with ABS, it is necessary to insert an air controller into the fan cover of extruder, to control the air volume and achieve better printing quality.”

    Could you clarify what that means and where to get the air controller from as no one seems to know.

    #2278

    haishen201
    Participant

    This should be to control the air flow so that more wind can be blown into the model at ABS, so that the model is not easy to curl, so model‘s addresses:http://www.thingiverse.com/thing:2316667 it named “extruder_air-duct”

    #2281

    misudo
    Participant

    Thanks for the response. I actually did print the air duct part, but could not find the way to fit them inside the extruder.

    do you have a picture or could you elaborate, please?

    #2283

    haishen201
    Participant

    I updated the picture on this website~

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.