This topic contains 1 reply, has 2 voices, and was last updated by  mc_ott 1 month, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #2642

    Frank S.
    Participant

    Hallo,
    der Drucker bleibt immer wieder stehen und zeigt den Fehler 12072 an.
    Was kann das sein?
    Ich denke es ist der Flachbandstecker, doch wo bekommt man da Ersatz dafür her?
    Es ist schlimm, dass es immer neue Probleme gibt, aber leider keine Hilfe von Mostfun!
    Viele Grüße
    Frank

    Hello,
    the printer always stops and displays error 12072.
    What could that be?
    I think it is the flat-band plug, but where you get as replacement for it?
    It is bad that there are always new problems, but unfortunately no help from Mostfun!
    Best regards
    Frank

    #10015

    mc_ott
    Participant

    I don’t think the ribbon cable is the problem, I suspect the contacts of the flat ribbon cable is the issue. If you move the cable slightly while cleaning the nozzle or oiling the rails, you will get errors if contact points move inside the connector. I had a problem with that connector (error 1204 when switching on the printer) after I changed the PTFE tube section in the heat-block as mine had melted and was blocking the filament flow. After playing with the ribbon cable very gently, I fixed it, without removing it. That ribbon cable connector is one of the weak design points of this printer as the contacts can be misaligned very easily. Good luck!

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.